1. Is the tooth of the small gear of the X-axis external encoder severely worn.

2. Is the small gear lifting spring stuck or too loose, causing the small gear to be unable to engage effectively with the measuring rack.

3. Is there any gap between the key connecting the small gear and the shaft due to wear.

4. Whether the large gear shaft is severely worn, whether the coupling between the synchronous belt pulley and the shaft is loose, whether the tightness of the synchronous belt and the effective connection of the small belt pulley tensioning sleeve at the motor end are effective.

5. Check for any movement of the car's swing arm and clamp rod, including the movement of the buffer cylinder.

6. Whether the external encoder cable is affected by other power sources, and whether the motor power cable is aging, it needs to be replaced.

7. Is there a gap between the clamping reference surface of the clamp and the angle steel.

8. Can the pliers firmly grip the angle steel.

Sun

info@jntime.com

Tel/Whatsapp: +86 13606411517